Pentair screenlogic not working1/2/2023 ![]() ![]() When Gatsby builds your web/application/site you will notice it builds most of your site in HTML and CSS which is both SEO friendly and fast to the browser. It’s magical! Gatsby Application “Builds” The ScreenLogic2 Interface Wireless Connection Kit (P/N 521964) can be used to eliminate the need to run this wire where impossible or impractical to do so.Gatsby is a free and open source framework based on React JS that helps you build incredibly fast websites which you can export in mostly HTML and CSS (and React where you need it). "Note: The above ScreenLogic Interface Kits (520502) require a four-wire, 22-gauge wiring connection from the IntelliTouch or EasyTouch Controller Load Center COM port to the protocol adapter within the home. I was just hoping part of the kit I already had installed given my system already has the wireless pentair controller. My question was really around the wireless connection which they have an entire kit for (p/n 521964). I would also contact the manufacturer of your existing pool controller to see if third party integration is even a possibility with your current model to make sure your not on a wild goose chase This will then allow for a easy integration and also provide an app for further control. My best advise is to install a verifiable pool controller that has a ip driver available. Still searching for some advice in this scenario. My sense is that others must have installed in some situations without a direct cable connection. ![]() There are several parts to buy or that you could buy so wanted to make sure i get it right. Pentair sells an entire Wireless Package for its Screenlogic system but the wireless receiver looks identical to the one i already have installed. The other scenario that is less clear is using the existing Pentair wifi used for EZtouch remote to broadcast to a Pentair transceiver, then the transceiver integrates into the home network (or maybe even rs232). I think i have it understood for the scenario running a wire to the control unit. I don't recall ever seeing a pentair EZ touch driver so that could also be a limiting factor. It also has to be a unit that allows for integration. Every pool that I've integrated needed a wire to the controller to either provide a network connection or to use rs232. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |